Today’s article will lay down the steps on how to install a black corrugated drainage pipe with laser level! A corrugated drainage pipe, also known as a sewer pipe is mostly manufactured out of a PVC material for durability. In drain pipes, it is placed beneath your septic tank with the aid of gravel in an underground hole that is dug up to place it.
Essentially, these pipes need to be heavy-duty so they can contain and allow the flow of septic material within the pipes. However, you need to be extremely accurate when installing these since the alignment matters! So, today, we will be exploring the steps needed to install a black corrugated drainage pipe using a laser level.
How to install a black corrugated drainage pipe with laser level?
In terms of the tools and equipment, you will need to install a black corrugated drainage pipe with a laser level, we recommend using a backhoe, some Gravel, PVC self-priming glue, some Geotextile fabric, and a laser level.
When you have all your tools on hand, here are the steps to follow:
- Your first step is to dig out the soil to make a trench according to the plan you are using. You need to make sure that the waste material and water are equally distributed all over so, use a backhoe to accurately dig the trench and make it level.
- Next, you will add at least 8 inches of gravel at the trench’s bottom. Your corrugated pipe might have some tiny holes in it, make sure the gravel is larger than these.
- After this, you will place the corrugated black pipe atop the gravel and make sure the corrugated part is mostly facing down. Then connect the pieces using the PVC self-priming glue
- This is where you’ll need the level! Place it on the PVC and make adjustments to the pipe by pushing the corrugated parts of the pipe in the gravel until your bubble appears in the center of the level. In any area that the pipe is too low, add gravel to raise it.
- You may also glue the corrugated pipe’s ends to the un-corrugated PVC pipe that is already present.
- Then you can add about 6 to 8 inches of gravel atop the pipe.
- Your final step is to place one later of the geotextile fabric on top of the gravel. It ensures that no soil penetrates the gravel area. The geotextile fabric is also inconspicuous so it won’t look different than the ground. Finally, fill the trench up with soil.
And that’s it! That’s all you need to do to successfully know how to install a black corrugated drainage pipe with laser level.
We hope our readers can get the accurate information they will need from the insights we have given above!